Coatings produced from SR3602-37W provide:
|Appearance||Viscous Red/Brown Liquid|
|Viscosity||4000-6000 mPas @ 23°C|
|Non-volatiles||34 – 36%|
|Density||~1.1 g/mL @ 23°C|
These figures are given as a guide. Full specifications available on request.
SR3602-37W is typically used in the following applications:
The excellent chemical resistance of these polymers leads to applications in container coatings, “non-stick” cookware, electronics, and other areas. Coatings can be produced from SR3602-37W that meet requirements of FDA regulations 177.2450 and can therefore be used in the manufacture of cookware coatings.
The solvent in this material is N-methyl pyrrolidone; further thinning if required should be carried out with N-methyl pyrrolidone. This solvent can also be used for cleaning of equipment as necessary.
SR3602-37W is supplied as a solution; care must be taken to enable the solvent to be removed slowly to avoid blistering of the film. During curing, the temperature of the object should be increased slowly up to the final cure temperature to avoid blistering of the coating due to final release of solvent. Final cure temperature of >220°C is required.
The solvent system for SR3602-37W is hygroscopic, i.e., will slowly absorb moisture from the atmosphere. 1-2% water content should not affect performance, but higher levels will lead to thickening of the product and difficulty in obtaining an acceptable impregnation. For this reason the applicator tank should be closed.
It is advised not to mix used material with unused product for storage, although topping-off the process tank with fresh material is acceptable.
In the original sealed container these products have a shelf life of 18 months when stored below 35°C. Solution viscosity will increase over time. The rate of increase depends upon solvent, % solids and storage conditions. The increase in viscosity does not affect polymer performance. The viscosity can be adjusted with additional solvent and the material can be used with no
Information on the safe handling of this material is available on the relevant Material Safety Data Sheet (MSDS). Further information is available on request.
Specific local inquiries should be directed to Cymer-Dayton, LLC. To the best of our knowledge this product meets the
definition of a polymer under REACH, and its components are preregistered as substances. The material, or components, is either on the TSCA inventory list or is exempt from the requirement to be listed.
The foundation for all partnerships is the relationships we develop and foster with our customers. The customer’s success is our primary objective, and that success is built on a deeply-rooted commitment, at all levels of the company, to safety, quality and success in all aspects of our work.
Contact us today to find out how we may be able to help meet your goals.